# MODULUS OF Elasticity (MOE) (From Your Data Set)

Format of Your Data - Your data should be in the following format:
• Columns 1-10 contain a specimen id
• Columns 12-16 contain the initial moisture content (i.e. 15.00 or 15.0)
• Columns 18-26 contain the specimen property (in$106$psi or MPa)
• Columns 28-32 contain the temperature ( degrees in Fahrenheit, i.e., 23)
WARNING!! You must have data for each variable. If data is missing, you must enter a period ( . ) to hold its place. If not, the program will put a 0.000 in its place when it writes out the results. This could cause you further problems in future calculations.

Before you proceed, you must transfer this datafile to www1.fpl.fs.fed.us via anonymous ftp. You must place it in the pub/data directory. (If ftp does not run on your machine, e-mail your data to the address given below and it will be placed in the directory.)

The program will calculate an adjusted MOE for the targeted temperature for each specimen, and write it out, along with your original input data, to a file that has your original filename with an extension .res added to it. (For example, if you sent a data set called himom, you will get back a data set called himom.res.) You can then retrieve your file via anonymous ftp from the pub/data directory.

Please enter the name of the data set you have put in our /pub/data directory for which you would like adjusted MOE values.

Initial Property Value Format(PICK ONE)

$106$psi (e.g., 1.8711)
MPa (e.g., 12900)

ASTM D-1990 Model
New MOE Model

Fahrenheit

For further information on this program, contact James Evans or call him at (608) 231-9332.